Overhaul kit consisting of: deep groove ball bearing ø12x24x6 with acrylonitrile butadiene rubber (NBR) seal on both sides snap ring ø25.9x23.5x1.2 in carbon steel needle roller bearing ø17.0x25.0x18.0 with rubber protection material

If your vehicle is equipped with Malossi crankshaft art. 5314548 (5312810 - 5313275 out of production) , must replace original fixed cover and hub with those included into this kit, in order to install Multivar 2000 MHR Aluminum art. 5118678 .

These new intake manifolds are supplied split up: the intake rubber can be rotated into the flange according to the specific requirements of the vehicle, in order to locate which is the best angle for the carburettor assembly.

Thanks to the big experience gained on racing circuits, Malossi can propose now a new 5 mm spacer, to be placed between the crankcase and the reed valve to improve the performances of the vehicle.